HOME>PRODUCTS>BENDING ROLL>BS-B Pinching type 4 rolls

BENDING ROLL

Standard machine serie

Customized machine series

BS-B Pinching type 4 rolls

Ideal 4 rolls bending machine Edge bending is possible with 4 rolls machine which 3 rolls machine is impossible. (Center adjustment is equipped)

Ideal 4 rolls bending machine Edge bending is possible with 4 rolls machine which 3 rolls machine is impossible. (Center adjustment is equipped)

Processible Dimensions at Machine

Processible Dimensions at Machine

 

  • The pre-bending processing is not required. From edge bending to cylindrical forming is possible in one process.
  • All rolls are quenched and grinded, so stainless steel or aluminum can be processed without any damages on surface.
  • The roundness is accurate by locking side roll (No1 to No3) perfectly after upper position.
  • The barrel shape or conical shape cylinder formation is prevented by synchronized mechanism for roll balance with adjustment of center bearing.
  • Repetition of bending production is simple with setting up the numbers by dial type setting meter.

 

BS-B Pinching type 4 rolls BS-B 2500×6t

BS-B Pinching type 4 rolls BS-B 2500×6t

Processing view
Processing view


Work examples

Work examples Work examples Work examples Work examples


Mail applications

  • Inner or outer cylinder of boiler
  • Solar heat device
  • Brake band
  • Ventilator
  • Train parts
  • Silo
  • Incinerator
  • Propane tank
  • Fire extinguisher tank
  • Electric wire dram
  • Pole trans
  • Automotive parts
  • Airplane pats
  • Exterior panel
  • Motor casing
  • Air conditioning duct

Production procedure

<Production procedure>
Production procedure:One process forming

1.Load the work piece to the machine center --- 2.Lift the No.2 roll --- 3.Lift the No.1 roll -- 4.Rotate the rolls --- 5.Lower the No.1 roll & Lift the No.3 roll --- 6.Rotate the rolls --- 7.Lower the No. 2 & 3 rolls & Unload the work piece

<Large diameter forming>
Production procedure:Large diameter forming

1.Load the work piece to the machine center --- 2.Lift the No.2 roll --- 3.Bend the plate end --- 4.Lower the No.1 roll --- 5.Lift the No.3 roll --- 6.Bend the plate end --- 7.Lift the No. 1 & 3 rolls and perform roll forming --- 8.Lift the No.1 & 3 rolls gradually --- 9.Process complete


Standard specifications

Standard specifications

  • The data shown above is tested with SS400 (steel), therefore it can be changed depends on different materials. Please contact us for more information. Specifications may be subject to change without prior notice.
  • Please prepare the following information for inquiry.
    Material, production size(minimum maximum), production amount(per day), work sheet size (thickness, width, length,), previous process, accuracy of roundness.

Automatic feeding device

自動供給取出装置

Safety cover


Discharge device
Feeding device
Safety cover

Automatic feeding procedure

Work feeding                Edge bending                                    Roll forming                            Discharge

Automatic feeding procedure


Work supporting roll (option) / Work suspension device (option)

 

1.Work supporting roll (option)
Preventing the deformation of roundness from work's weight and provide stabile processing by supporting roller, which located beside of roll.

2.Work suspension device (option)
Preventing the work's one end and other end to be feed and bend at once when work processed diameter is smaller than expected or bend with work's weight.